tilepath and clamping... again

Use this forum for general user support and related questions.
Forum rules
Please upload a testscene that allows developers to reproduce the problem, and attach some images.
User avatar
lacilaci
Donor
Donor
Posts: 1969
Joined: Fri May 04, 2018 5:16 am

Re: tilepath and clamping... again

Post by lacilaci »

Dade wrote: Sat Nov 03, 2018 1:23 pm
lacilaci wrote: Sat Nov 03, 2018 6:30 am Ok, but there is an issue when you look at the monkey in testscene or, screenshots in the original post right? Tilepath in beta1 does sample some high power samples and gives way stronger lighting than normal path. This results in fireflies in some cases.
As far as I can tell, it was only related to the "too small" clamping value, if you increase the value TILEPATH and PATH produce the same image.
Ok, I'm gonna get back to this cause I'm not sure if that is true.
User avatar
lacilaci
Donor
Donor
Posts: 1969
Joined: Fri May 04, 2018 5:16 am

Re: tilepath and clamping... again

Post by lacilaci »

Well, I don't know... This doesn't seem right.
This is way too big of a difference.
Same clamping value, it's tilepath vs normal path. It almost looks as if clamping works very differently between the two.
Only if clamping is disabled I get the same results.
Attachments
path_clamping.jpg
tilepath_clamping.jpg
luxcoreDLCS_issue2_meshlights.blend
(3.87 MiB) Downloaded 111 times
Post Reply