Page 1 of 1
Missing halt condition (check error log)
Posted: Mon Jun 11, 2018 8:16 am
by Mark Oh
Where should it change?
Re: Missing halt condition (check error log)
Posted: Mon Jun 11, 2018 1:51 pm
by B.Y.O.B.
You have to enable at least one of the halt conditions in the render tab:
https://wiki.luxcorerender.org/BlendLuxCore_RenderPanel
This is necessary if you render an animation or multiple render layers, because otherwise LuxCore would never stop rendering the first frame or the first render layer.
Re: Missing halt condition (check error log)
Posted: Mon Jun 11, 2018 2:12 pm
by Mark Oh
thanks