LuxCoreRender Forums • Displacement Problem - Page 2

Page 2 of 2

Re: Displacement Problem

Posted: Mon Dec 07, 2020 6:15 pm

by DionXein

Dade wrote: ↑Sun Dec 06, 2020 11:24 pm As far as I remember, you have to set the mesh to smooth in order to not have the faces to "explode" across the sharp edges.

I did right like u said and get interesting result.

After UV reset everything is ok

Re: Displacement Problem

Posted: Mon Dec 07, 2020 7:07 pm

by rocknkaya

this is uv reset. yes it works i think but edges now a bit different